7.39. Socionext Synquacer

Socionext’s Synquacer SC2A11 is a multi-core processor with 24 cores of Arm Cortex-A53. The Developerbox, of 96boards, is a platform that contains this processor. This port of the Trusted Firmware only supports this platform at the moment.

More information are listed in link.

7.39.1. How to build Code Locations Boot Flow

SCP firmware –> TF-A BL31 –> UEFI(edk2) Build Procedure

  • Firstly, in addition to the “normal” build tools you will also need a few specialist tools. On a Debian or Ubuntu operating system try:

    sudo apt install acpica-tools device-tree-compiler uuid-dev
  • Secondly, create a new working directory and store the absolute path to this directory in an environment variable, WORKSPACE. It does not matter where this directory is created but as an example:

    export WORKSPACE=$HOME/build/developerbox-firmware
    mkdir -p $WORKSPACE
  • Run the following commands to clone the source code:

    git clone https://github.com/ARM-software/arm-trusted-firmware -b master
    git clone https://github.com/tianocore/edk2.git -b master
    git clone https://github.com/tianocore/edk2-platforms.git -b master
    git clone https://github.com/tianocore/edk2-non-osi.git -b master
  • Build ATF:

    cd $WORKSPACE/arm-trusted-firmware
    make -j`nproc` PLAT=synquacer PRELOADED_BL33_BASE=0x8200000 bl31 fiptool
    tools/fiptool/fiptool create \
          --tb-fw ./build/synquacer/release/bl31.bin \
          --soc-fw ./build/synquacer/release/bl31.bin \
          --scp-fw ./build/synquacer/release/bl31.bin \
  • Build EDK2:

    export PACKAGES_PATH=$WORKSPACE/edk2:$WORKSPACE/edk2-platforms:$WORKSPACE/edk2-non-osi
    export ACTIVE_PLATFORM="Platform/Socionext/DeveloperBox/DeveloperBox.dsc"
    export GCC5_AARCH64_PREFIX=aarch64-linux-gnu-
    unset ARCH
    . edk2/edksetup.sh
    make -C edk2/BaseTools
    build -p $ACTIVE_PLATFORM -b RELEASE -a AARCH64 -t GCC5 -n `nproc` -D DO_X86EMU=TRUE
  • The firmware image, which comprises the option ROM, ARM trusted firmware and EDK2 itself, can be found $WORKSPACE/../Build/DeveloperBox/RELEASE_GCC5/FV/. Use SYNQUACERFIRMWAREUPDATECAPSULEFMPPKCS7.Cap for UEFI capsule update and SPI_NOR_IMAGE.fd for the serial flasher.

    Note #1: -t GCC5 can be loosely translated as “enable link-time-optimization”; any version of gcc >= 5 will support this feature and may be used to build EDK2.

    Note #2: Replace -b RELEASE with -b DEBUG to build a debug. Install the System Firmware

  • Providing your Developerbox is fully working and has on operating system installed then you can adopt your the newly compiled system firmware using the capsule update method:.

    sudo apt install fwupdate
    sudo fwupdate --apply {50b94ce5-8b63-4849-8af4-ea479356f0e3} \
    sudo reboot
  • Alternatively you can install SPI_NOR_IMAGE.fd using the board recovery method.